I have tried to search but I did not see anything. Has there been any change to the measurements of the OE rubicon wheels from 2015 to today? I am wondering if I could do a swap of an older wheel.
Thanks for the help
JK wheels will work on a JL. At least the ones we had did.
JL Wheels have a slightly larger stud bore than the JK but they will fit. It may require running a drill bit through them lightly just to deburr the old holes. There will likely be burrs on the wheel if they were previously mounted because of where the lug nut taper presses against the wheel and mushrooms the wheel material. We had wheels on our JK that we put on our gladiator and I had to deburr the holes. It didn't remove any wheel material in an unsafe manner; basically just cleaned up the holes. But the wheel studs on the JT are longer so you cannot use JK lug nuts. Plus the JL is a 14 mm stud where as the JK studs are smaller than that so you'll need JL lug nuts anyways.
Then, because we liked the wheels so much, when we bought our JL, we bought another exact set of wheels and put them on our JL and I didn't have to debur them at all. Wheels slid over the studs just fine.
Both of these Jeeps are running the exact same JK wheel: