tallguy26
Member
Quick guide on how to install the Mopar door sill guards on your new JL wrangler. Mopar part# 82215394
We will start with the front.
Step 1: Clean the area then wipe down with the included alcohol pad.
Step 2: Grab the correct door sill. They are labeled on the bottom for door and side.
Step 3: Line the small arrow on the guard up with the seam on the body.
Step 4: Making sure that you have the guard all the way back against the seam remove the 3M tape and apply pressure to guard to make it stick.
If you have a 2 door just repeat for the passenger side and you are done.
Now for the Rear doors
Step 5: Grab the shorter rear guard for the correct side. These are labeled like the fronts.
Step 6: Line up the small arrow with the body seam as shown.
Step 7: Make sure that you are flush with the door seam and remove the 3M tape cover and apply pressure.
Repeat for passenger and you are all done.
We will start with the front.
Step 1: Clean the area then wipe down with the included alcohol pad.
Step 2: Grab the correct door sill. They are labeled on the bottom for door and side.
Step 3: Line the small arrow on the guard up with the seam on the body.
Step 4: Making sure that you have the guard all the way back against the seam remove the 3M tape and apply pressure to guard to make it stick.
If you have a 2 door just repeat for the passenger side and you are done.
Now for the Rear doors
Step 5: Grab the shorter rear guard for the correct side. These are labeled like the fronts.
Step 6: Line up the small arrow with the body seam as shown.
Step 7: Make sure that you are flush with the door seam and remove the 3M tape cover and apply pressure.
Repeat for passenger and you are all done.